The F.A.T. Wrench, which stands for Firearm Accurizing Torque, is the torque wrench with which Wheeler Engineering brought torque-controlled tightening to the enthusiast's workbench. You set the desired value and the wrench repeats it for every screw, without relying on hand sensitivity.
It is the difference between a mount that holds and one that does not: undertightened base screws loosen under recoil and shift the point of impact, while overtightened screws crush the scope tube or ruin the threads in the receiver. The working range goes from 10 to 65 in-lbs and covers the hardware typical of firearms. The ten included bits are made of hardened S2 steel with a black anti-rust phosphate coating and include hollow-ground flat blades, which reach the bottom of the slot without marking the screw head. The tip is magnetized and the handle has a knurled rubber overmold that reduces fatigue when the torque increases.
Main features
Torque range from 10 to 65 in-lbs
Ten hardened S2 steel bits with black phosphate coating
Hollow-ground flat blades
Magnetized tip that holds the bit
Handle with knurled rubber overmold
Recommended use
For tightening scope bases and rings, action screws, and general hardware for which the manufacturer specifies a torque value.