Leupold STD one-piece base for early Smith & Wesson models and Husqvarna Carl Gustaf, gloss black
Leupold STD one-piece base for early Smith & Wesson models and Husqvarna Carl Gustaf, gloss black
SKU:LEU.49989
In stock
Couldn't load pickup availability
- Manufacturer warranty: lifetime – Leupold · terms
- Shipping: Italy €12,00 · EU €29,00 · other countries at checkout
- 14-day right of withdrawal for consumers
- Secure payment: PayPal, credit card, bank transfer · no surcharge for PayPal or card
Leupold STD one-piece base for early Smith & Wesson models and Husqvarna Carl Gustaf, gloss black
The Leupold STD one-piece base is the interface between the receiver of early Smith & Wesson models and Husqvarna Carl Gustaf rifles and the rings that hold the scope; it defines the position, height, and alignment of the optic, upon which zero retention under recoil and correct eye relief depend. It is a dedicated mount, machined to the weapon's dimensions, which attaches to the factory-drilled holes without any modifications. The gloss black finish matches the polished bluing of classic-style firearms.
In the Standard system, the front ring rests on a dovetail mount that rotates into place, while the rear ring is held by two opposing windage screws. During barrel alignment, the windage screws allow the scope to be centered laterally without consuming the scope's internal adjustment range, which thus remains available for fine-tuning; for larger vertical corrections, Leupold provides for the use of shims, leaving the elevation turret free for ballistic compensation. The construction is steel, and the manufacturer recommends the STD system for standard calibers up to .300 Win. Mag. The specified torque settings are 22 in-lb for the base-to-receiver screws and 45 in-lb for the windage screws.
Main features
- Leupold STD mounting system
- Configuration: one-piece
- Material: steel
- Finish: gloss black
- Windage adjustment on the rear base via opposing screws
- Leupold torque settings: 22 in-lb for base/receiver screws, 45 in-lb for windage screws
- Required rings: Leupold STD rings
- Leupold part number: 49989
Recommended use
Leupold indicates this part number for the following firearms:
- Smith & Wesson rifle, early models
- Husqvarna Carl Gustaf and Crown Grade
- J.C. Higgins post-1955
The mount is completed with Leupold STD rings, available for 1-inch and 30mm tubes in low, medium, high, and super high heights: the height must be chosen based on the scope's objective lens diameter and barrel clearance.
Package contents
- 1 mounting base
- Receiver mounting screws
Rings and scope are not included: the system requires Leupold STD rings, which must be ordered separately in the correct diameter and height.
Manufacturer part number: 49989
Share
