Lee Precision Case Length Gage with shellholder 40 S&W 90154
Lee Precision Case Length Gage with shellholder 40 S&W 90154
SKU:LEE.90154
In stock
Couldn't load pickup availability
- Shipping: Italy €12,00 · EU €29,00 · other countries at checkout
- 14-day right of withdrawal for consumers
- Secure payment: PayPal, credit card, bank transfer · no surcharge for PayPal or card
Lee Precision Case Length Gage and Shellholder 40 S&W 90154
The Case Length Gage and Shellholder is a unit consisting of a length gage and a dedicated shellholder that Lee Precision uses to trim cases to length and square the case mouth. This unit works with the 40 S&W: the trim length is determined by the geometry of the gage, so it does not depend on adjustments or operator readings and remains identical for the entire batch of cases.
The case is held by the shellholder while the cutting tool rests on the gage: the cut stops automatically when the case reaches the specified length. The unit acts as a go/no-go gauge: if the case is not cut, it means it is already within limits. Lee specifies a tolerance for these units of +.000/-.015 inches, reduced to +.000/-.010 inches for cartridges that headspace on the case mouth, such as the 40 S&W, where the length directly affects headspace and the consistency of the operating cycle. The trimmed mouth remains perpendicular to the case axis, a condition that makes the crimping phase uniform. The system is entirely mechanical and requires no calibration or maintenance.
Main features
- Length gage and shellholder dedicated to the 40 S&W
- Mechanical stop: length repeatable across the entire batch of cases
- Lee tolerance of +.000/-.010 inches for cartridges that headspace on the mouth
- Functions as a go/no-go gauge: if the case is not cut, it is already to size
- Squares the case mouth perpendicular to the axis
- Requires no adjustments or calibration
Recommended use
The gage must be paired with a Lee cutting tool sold separately: Cutter and Lock Stud 90110, Cutter with Ball Grip and Lock Stud 90275, or the Deluxe Case Conditioning Combo 92160, which includes a cutter and lock stud, chamfer tool, primer pocket cleaner, and power grip shell holder. The Cutter and Lock Stud is universal; one is sufficient for all cartridges with a bullet diameter smaller than .475 inches, and it is used by hand or with an electric drill. After trimming, it is advisable to chamfer and deburr the mouth with the Lee Chamfer Tool 90109.
Package contents
- Case Length Gage 40 S&W
- Dedicated shellholder
- Not included: cutting tool (Cutter and Lock Stud 90110 or equivalent)
Manufacturer code: 90154
Share
