Leupold STD one-piece base for Remington 750, 7400 and 7600 matte black

Leupold STD one-piece base for Remington 750, 7400 and 7600 matte black

The Leupold STD one-piece base is the interface between the Remington 750, 7400 and 7600 receiver and the rings that hold the scope: it defines the position, height, and alignment of the optic, which determine zero retention under recoil and correct eye relief. It is a dedicated mount, machined to the weapon's specifications, which attaches to the factory-drilled holes without any modifications. The matte black finish reduces glare and is consistent with matte blued or treated firearms.

On the Standard system, the front ring rests on a dovetail mount that rotates into place, while the rear ring is held by two opposing windage screws. During bore alignment, the windage screws allow the scope to be centered laterally without using up the internal adjustment range of the scope, which remains available for fine-tuning; for larger vertical corrections, Leupold provides for the use of shims, leaving the elevation turret free for ballistic compensation. It is made of steel, and the manufacturer recommends the STD system for standard calibers up to .300 Win. Mag. The specified torque settings are 22 in-lb for the base/receiver screws and 45 in-lb for the windage screws.

Main features

• Leupold STD mounting system
• Configuration: one-piece
• Material: steel
• Finish: matte black
• Windage adjustment on the rear base via opposing screws
• Leupold torque settings: 22 in-lb base/receiver screws, 45 in-lb windage screws
• Required rings: Leupold STD rings
• Leupold item code: 53056

Recommended use

Leupold specifies this item code for the following firearms:

• Remington 750
• Remington 7400
• Remington 7600
• Remington Model 4 and Model 6

The assembly is completed with Leupold STD rings, available for 1-inch and 30mm tubes in low, medium, high, and super high heights: the height should be chosen based on the diameter of the scope's objective lens and barrel clearance.

Package contents

• 1 mounting base
• Receiver mounting screws

Rings and scope are not included: the system requires Leupold STD rings, to be ordered separately in the correct diameter and height.

Manufacturer code: 53056